Monday, June 28, 2010

First video on Woodworking by Hand!

Here's a first movie! As an actor I am a beginner but I hope to improve quickly! As subject I chose just the tool I was working today: the plough plane.


Sunday, June 27, 2010

Abrasive paper and double-side tape: together for flattening

The abrasive paper attached to a plan surface is a good way to flatten soles of metal planes for significantly improving their performances. Usually I use spray glue that allows a valid bur reversible bonding so you can easily replace the abrasive when it is exhausted. The only drawback is the glue residue left on the glass plate that has to be cleaned with alcohol every time . An alternative way is to use double-sided adhesive tape which provides excellent grip and when removed leaves no residue on glass and results in faster replacement operations .
If you can't find a full sheet of sandpaper wide enough then you could join two narrow strips togheter.
. The tape thickness is minimal and does not affect the flatness degree useful to obtain a good levelled surface.

Repairing a damaged plane body

Old wood planes are tools often challenging the century, continuing today to give satisfaction to those who use them. When accidentally  a damage occurs, who causes it feels very guilty for having interrupted a century-old life . The only partial relief could be a good repair. The accidental fall of a cast iron  plane often results in a lesion at the point of greatest weakness: on the sides, near to the mouth. This happened to my Stanley # 3. After listening to other suggestions, I developed this system to repair this lesion type, which was particularly simple and effective. After appropriately clamping the  plane body to avoid unwanted movements we can drill 4 mm holes (slightly larger than electrodes that measure approximately 3.5 mm) along the lesion.






















At this point,  cast iron is properly heated with a torch or any fire, and the arc welding is carried out. I used a small inverter welder with specific cast iron electrodes. In fact it is easier fill the holes than a concave groove, which instead requires some experience. ( In the pics I forgot to take a shot just after soldering) .
I then proceeded to flatten the sole and sides, which were however almost completely aligned. And here it  is returned to its former glory (or almost) and produce the usual thin shavings.